Page 1 of 1

How to toggle displays? MSP 13

Posted: Fri 23. Dec 2016, 15:17
by entapir
Hi! I just replaced my old MacBookPro and Cintiq companion hybrid with an MSP 13 i7. Because it is more powerful than my old MBP, I want to try to use it as both a workstation with additional screen and mobile tablet.

With a USBC to HDMI converter, it was no problem to run two displays from the MSP, BUT the stylus works only on the additional screen.
I can not find any settings in the Wacom or in Windows that allows me to remap the drawing area or switch between screens.

Have I missed something or there is no possibility of using "toggle screen" on this device?

Re: How to toggle displays? MSP 13

Posted: Tue 27. Dec 2016, 10:17
by wacom1
There are two settings, which I would check: a) Windows TabletPC settings -> Setup -> Stylus should be mapped to MSP, b) in Wacom Tablet properties -> calibration, the MSP should be selected. - At the moment the MSP driver has no 'display toggle' option, as you would normally expect the pointer underneath the pentip (that is how it SHOULD work of course. We may be able to add 'display toggle' in a future driver version.)

Re: How to toggle displays? MSP 13

Posted: Tue 27. Dec 2016, 10:32
by entapir
wacom1 wrote:There are two settings, which I would check: a) Windows TabletPC settings -> Setup -> Stylus should be mapped to MSP, b) in Wacom Tablet properties -> calibration, the MSP should be selected. - At the moment the MSP driver has no 'display toggle' option, as you would normally expect the pointer underneath the pentip (that is how it SHOULD work of course. We may be able to add 'display toggle' in a future driver version.)

It worked! :D thx