Page 1 of 1

cursor jumping then nothing

Posted: Fri 13. Apr 2018, 15:18
by Isometric
Hi,
I just dug up my Intuos draw or P S/CLT-490, as the software calls it and installed the drivers using the Wacom desktop center. After restarting the system as instructed by the software, the cursor was jumping to the bottom center of my screen every second or so. The intervals were always the same and after restarting again the tablet stopped reporting input altogether...
Thanks, Iso.

Re: cursor jumping then nothing

Posted: Sat 14. Apr 2018, 08:02
by wacom1
Unplug and replug the tablet, open WDC aand use backup settings -> reset settings. If that makes no difference, check your system for possibly interfering software (especially mouse/keyboard related).