Wacom Forum - Wacom Europe GmbH

This is going to be long, please bear with me.

So I have my tablet, I plugged it in, and there were lights in it. But the cursor would not move. Even if the light was responding to my stylus.
The disk was misplaced, and I don't have it in the moment, so I installed a driver for Wacom Intuos. My device is Intuos CTL-490 Pen Only Device, as shown by the device manager. It has this yellow triangle though.

Upon following the tablet driver's installation demands, I tried restarting it but to no avail. It has been going on for a while now, sometimes my task bar would say device driver was not successfully found. The cursor wouldn't budge. I opened the Wacom Tablet Properties and a window appeared saying, "A SUPPORTED TABLET WAS NOT FOUND." Using the driver I've installed from the official site, I've tried reinstalling it many times but still, it wouldn't even move.

I went to the drivers manager in my computer, and went to the Human Interface Devices before and it still had this yellow annoying triangle in it.

I need your help, I'm desperate since I am only a student and I bought it with my hard-earned savings. Any helpful reply would be truly appreciated.

My main problem is, the cursor wouldn't respond. I just need it to move then I'll deal with the pressure sensitivity later.

This is going to be long, please bear with me.

So I have my tablet, I plugged it in, and there were lights in it. But the cursor would not move. Even if the light was responding to my stylus.
The disk was misplaced, and I don't have it in the moment, so I installed a driver for Wacom Intuos. My device is Intuos CTL-490 Pen Only Device, as shown by the device manager. It has this yellow triangle though.

Upon following the tablet driver's installation demands, I tried restarting it but to no avail. It has been going on for a while now, sometimes my task bar would say device driver was not successfully found. The cursor wouldn't budge. I opened the Wacom Tablet Properties and a window appeared saying, "A SUPPORTED TABLET WAS NOT FOUND." Using the driver I've installed from the official site, I've tried reinstalling it many times but still, it wouldn't even move.

I went to the drivers manager in my computer, and went to the Human Interface Devices before and it still had this yellow annoying triangle in it.

I need your help, I'm desperate since I am only a student and I bought it with my hard-earned savings. Any helpful reply would be truly appreciated.

My main problem is, the cursor wouldn't respond. I just need it to move then I'll deal with the pressure sensitivity later.

This looks like an issue within Windows.
When the yellow triangle shows, it means that the computer could not recognize the device successfully.
Did you try another USB port?
Could you try the Intuos on another PC/Mac?
Do you have another Micro-USB Cable that fits?

A reboot should be helping as well - but you should unplug the Intuos first, and only plug it in as soon as Windows is started up completely.