Hello, everyone.
I've been using my 13HD for a while now and have developed some "sore" spots where I tend to do most of my work. (The pen tends to squeak and drags hard over these areas.) I'm mainly concerned because I believe these spots to be wearing my nibs down faster.
I've seen posts where people have replaced the screen protector, but what about just putting a second protector on top of the existing? The sore spots aren't so worn that they interfere with the display; they're only evident when you try to draw across them.
I'm hardly a professional, so I know some of you have run into this problem and have solutions...
Wacom Customer Support page: https://support.wacom.com/
Wacom Product Resources - Drivers, Manuals, Warranty Information & Others
Product Registration:
Please register our products on https://www.wacom.com/register
How do I register my Wacom device?
About ARM architecture-based computer support:
Check our FAQ: Does the Wacom driver support ARM architecture-based computers?
Wacom Product Resources - Drivers, Manuals, Warranty Information & Others
Product Registration:
Please register our products on https://www.wacom.com/register
How do I register my Wacom device?
About ARM architecture-based computer support:
Check our FAQ: Does the Wacom driver support ARM architecture-based computers?
13HD screen protector replacement
-
- Posts: 50
- Joined: Wed 18. Jan 2017, 14:21
Re: 13HD screen protector replacement
Well, I went ahead with my, "Add a second screen protector" plan. My original concern was that, with the added material between the pen and the screen, the parallax would become a problem. It's a little worse than before, but only near the edges of the screen. The protector I got was this:
http://a.co/dJ9FtRd
Feels virtually the same to the stock one.
http://a.co/dJ9FtRd
Feels virtually the same to the stock one.